Hi,
Before git.kde.org goes down I like to urge everyone to stop doing clones from git.kde.org.
Please use anongit.kde.org for reads and git.kde.org only for writes as explained here:
<a href="http://community.kde.org/Sysadmin/GitKdeOrgManual#Let_Git_rewrite_URL_prefixes" title="http://community.kde.org/Sysadmin/GitKdeOrgManual#Let_Git_rewrite_URL_prefixes">http://community.kde.org/Sysadmin/GitKdeOrgManual#Let_Git_rewrite_URL_pr...</a>
The system is now on the edge of breaking.
Best,
Comments
Re: Stop using git.kde.org immediately!!!!
By Tom Albers at 01/30/2011 - 19:57Hi,
git.kde.org will no longer accept clone requests. It will give you an error.
I will leave this in place for the next week or so, until everyone has their clones.
Best,
Toma
anongit.kde.org now updating instantly && sorry
By Tom Albers at 01/31/2011 - 16:46Hi All,
An apology is in place. I blamed all you guys for cloning from the wrong server in below mails, but in fact it looks like a problem on our side with the way we updated the anongit mirrors. We have changed it now.
Old situation: anongit was pulling the changes every 5 minutes. which actually took 6 minutes to complete, hence the increase in load. Especially when people were pushing, which made the negative loop accelerate.
New situation: the commits are now instantly pushed to the anongit mirrors. This means that whenever you push, the anongit mirrors directly have that change. No 5 minutes delay anymore. Unless a connectivity problem arises, but that will be corrected after 20 minutes or so.
Again, sorry for blaming you guys. Instead I can now say: bring it on :)
Best,
Toma
Sysadmin team